Tandy DCM-7 Operation Manual page 4

The FCC Wants You to Know
This equipment generates and uses radio frequency energy. If not installed and used properly,
that is in strict accordance with the manufacturer's instructions, it may cause interference to
radio and television reception.
It has been type tested and found to comply with the limits for a Class B computing device
in accordance with the specifications in Subpart J of Part 15 of FCC Rules, which are designed
to provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in .a particular' installation.
If this equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the in-
terference by one or more of the following measures:
• Reorient the receiving antenna
• Relocate the computer with respect to the receiver
• Move the computer away from the receiver
• Plug the computer into a different outlet so that computer and receiver are on different
branch circuits.
Warning
This equipment has been certified to comply with the limits for a Class B computing device,
pursuant to Subpart J of Part 15 of FCC Rules. Only peripherals (computer input/ouput
devices, terminals, printers, etc.) certified to comply with the Class B limits may be attached to
this computer. Operation with non-certified peripherals is likely to result in interference to
radio and TV reception.
2/86
300-Bps Intelligent Modem DCM-7 Operation Manual: .
©
1986 Tandy Corporation, Fort Worth, Texas 76102 U.S.A.
All Rights Reserved.
Reproduction or use, without express written permission from Tandy Corpora-
tion, of any portion of this manual is prohibited. While reasonable efforts have
been taken in the preparation of this manual to assure its accuracy, Tandy
Corporation assumes no liability resulting from any errors or omissions in this
manual, or from the use of the information contained herein.
Hayes ® is a registered trademark of Hayes Microcomputer Products, Inc.
XENIX® is a registered trademark of Microsoft Corporation.
10 9 8 7 6 5 4 3 2 1