TYPICAL CAB INSTALLATION USING THE MB100 BRACKET
Fig. 4
(Bracket sold separately)
IMPORTANT! Bracket mounting holes and wiring hole must be sealed so they are
completely waterproof. Sealant must be cab compatible.
IMPORTANT!
The alignment tabs on the wiring
port and the main harness plug
must match up when engaging
plug onto port.
YOU MUST TIGHTEN THE PLUG
UNTIL IT CLICKS PAST THE
DETENT LOCK.
Coax connections should be snug.
(A channel lock pliers may be used
DO NOT OVER TIGHTEN!
to carefully tighten the connection.)
Page 6