VuQube V20 Installation And Operating Instructions Manual page 14

STEP 2: ANTENNA CONFIGURATION FOR DIRECTV
The VuQube is factory pre-set for the DIRECTV 101 satellite. Unless the antenna has been
configured for another option since leaving the factory, PERFORM STEP 5 ONLY.
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then WAIT 4 MORE SECONDS.
2. Press and release the ON button 16 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. Set your receiver for round dish-1 satellite (do this through the receiver's satellite
set-up menu screens). Configuration is complete. Go to page 22.
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then WAIT 4 MORE SECONDS.
2. Press and release the ON button 8 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. Set your receiver for oval dish-2 satellites (do this through the receiver's satellite
set-up menu screens).
If you have an H23 receiver, choose the following dish configuration settings.
Dish Type: 02: 3-LNB (18"x20"), Switch Type: 02:Multiswitch.
Configuration is complete. Go to page 22.
Page 12
Single Satellite 101
button for 4 seconds.
DIRECTV Plus (satellites 101, 119)
button for 4 seconds.