Installation - VuQube V20 Installation And Operating Instructions Manual

ANTENNA UNIT LOCATION AND INSTALLATION (FIG 3.)
IMPORTANT! The antenna unit MUST be mounted to the air ride cab, NEVER to any structure mounted
directly to the frame (for example the headache rack). Mounting directly to the frame will
void the product warranty.
4. Determine the mounting location of the antenna unit using the following criteria:
a) The antenna unit is designed to be mounted to a vehicle with either an MB100, MB101
or MB200 mounting bracket (sold separately - for more information call King Controls
or visit our website at www.kingcontrols.com). FAILURE TO USE THE APPROPRIATE
BRACKET WILL VOID THE PRODUCT WARRANTY.
b) The antenna unit requires a 16" wide space for mounting.
c) It is highly recommended that the antenna unit extend a minimum of 4" above the
highest point of the cab or air shield for optimum satellite reception.
If you are unable to mount the antenna unit 4" above the cab due to height restrictions,
install with maximum clearance available. If the antenna unit is not high enough, you
may experience difficulty acquiring the satellite signal.
d) The antenna unit should be as far as possible from objects like smoke stacks, beacons,
logistic units, etc. that can physically block the satellite signal.
e) The wiring from the antenna unit may be run down the back of the cab and up into the
cab through an access bay, or a hole may be drilled in an appropriate location. There
must be no sharp bends in the wiring.
Fig. 3
The antenna unit MUST be mounted to the air ride cab,
NEVER to any structure mounted directly to the frame.
Page 4
MB100 or MB101 Mounting Bracket
(Sold separately)
IMPORTANT
MB200 Mounting Bracket
(Sold separately)