Antenna Configuration - VuQube V20 Installation And Operating Instructions Manual

SECTION 3
The VuQube Model V20 and V30 Automatic Satellite Systems are factory pre-set for DIRECTV
standard digital programming broadcast from the 101° W satellite.
If you also receive your local channels from DIRECTV's 119 satellite or if you subscribe to Dish
Network or Bell TV programming, you must use the VuQube hand held controller to
re-configure the antenna to work with your satellite service. Doing this will allow the VuQube to lock
on the correct satellites to receive your programming and also enable automatic satellite switching
via the receiver's remote control for multi-satellite service.
Antenna configuration is a one time procedure that MUST BE COMPLETED before using your
VuQube antenna. To configure your antenna, follow these steps:
1. SATELLITE SERVICE OPTIONS
Determine the service you want to program (pages 10-11).

2. ANTENNA CONFIGURATION

Configure the antenna for the service you chose in step 1. On pages 12-17, find your
service and follow the instructions in the box. Note: V20 controller shown. Procedure is
the same for both V20 and V30 controllers.
DIRECTV
Single Satellite 101 (Factory Pre-set) . . . . . . .Page 12
DIRECTV Plus . . . . . . . . . . . . . . . . . . . . . . . . .Page 12
Dish Network
Dish 500 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 13
Dish HD Eastern Arc . . . . . . . . . . . . . . . . . . . .Page 13
Dish HD Western Arc with Locals . . . . . . . . . .Page 14
Dish HD Eastern Arc with Locals . . . . . . . . . .Page 14
Dish HD Alternate with Locals . . . . . . . . . . . . .Page 15
Bell TV
Bell TV Standard Digital 91 . . . . . . . . . . . . . . .Page 16
Bell TV HDTV 82/91 . . . . . . . . . . . . . . . . . . . .Page 16
Bell TV HDTV 82/91 Alternate . . . . . . . . . . . . .Page 17
3. DISH NETWORK AND BELL TV CHECK SWITCH PROCEDURE
For all Dish Network and Bell TV services:
Configure your receiver for mobile use by running a check switch (page 18).
ANTENNA CONFIGURATION
Page 9