Config, Frame) Framed; Config, Frame, Framed) Edmac-On; Config, Frame, Framed, On) Edmac Master - Comtech EF Data CDM-500 Installation And Operation Manual

CDM-500 Closed Network Satellite Modem
6.5.24

(CONFIG, FRAME) FRAMED

SELECT FRAMING OPTION:
EDMAC-OFF EDMAC-ON (ENT)
Select EDMAC-OFF or EDMAC-ON, using the LEFT/RIGHT arrow keys, then press
Enter.
Embedded Distant-end Monitor And Control is enabled or disabled in this sub-menu.
If EDMAC-OFF is selected then none of the EDMAC features are available, even though
framing will still be enabled.
If EDMAC-ON is selected, the user is further prompted to select whether the unit is an
EDMAC master, or an EDMAC slave:
6.5.25

(CONFIG, FRAME, FRAMED) EDMAC-ON

SELECT EDMAC MODE:
MASTER SLAVE (ENTER)
Select MASTER or SLAVE, using the LEFT/RIGHT arrow keys, then press Enter.
An EDMAC MASTER is a unit which is local to the M&C computer, and which passes
messages, via the overhead, to a distant-end modem.
An EDMAC SLAVE is a unit which is not local to the M&C computer, which is at the
distant-end of a satellite link.
If MASTER is selected then the following sub-menu is displayed:
6.5.26

(CONFIG, FRAME, FRAMED, ON) EDMAC MASTER

EDIT DISTANT-END'S ADDR:
0240 (SEE HANDBOOK)(ENT)
Edit the address of the distant-end modem to which this unit will pass messages. Select
the digit to be edited with the LEFT/RIGHT arrow keys. Change the value of the digit
using the UP/DOWN arrow keys. Press Enter.
There is a restriction on values which can be entered here - they may only be in
increments of 10. This is automatically taken care of - the user may not edit the last digit
of the address. This has been implemented so that a single MASTER may pass messages
for up to 10 devices at the distant end. The valid range of addresses is from 10 to 9990.
But if SLAVE is selected, then the following sub-menu is displayed:
Rev. 1.3
Front Panel Operation
6–11