Door Control; Grant Access - Siemens SPCK 420 User Manual

User programming via the keypad
6
User Menus
6.2.11
6.2.12
28
Siemens AB
Security Products
The SMS operates using a standard protocol that is used in SMS telephones.
Please note that some PSTN operators do not provide the service of SMS over
PSTN. For SMS to operate over PSTN the following criteria is required:
Caller ID needs to be enabled on the telephone line.

Direct telephone line – not through PABX or other comms equipment.

Please also note that most Service Providers only allow SMS to a telephone

registered in the same country. (This is due to billing issues)

DOOR CONTROL

This option allows you to control all the doors of the system.
1. Scroll to DOOR CONTROL and press SELECT.
2. Select the door which should be controlled and press SELECT.
3. Select one of the door states listed below as new door state and press
SELECT.
NORMAL The door is in normal operation mode. A card with the corresponding
access rights is needed to open the door.
MOMENTARY The door is opened only for a timed interval to allow access.
LOCKED The door is locked. The door remains closed even if a card with the
corresponding access rights is presented.
UNLOCKED The door is unlocked.

GRANT ACCESS

NOTICE
These menu options are not available if the ALLOW ENGINEER or ALLOW
MANUFACTURER options are disabled in the OPTIONs menu. These options
can be enabled or disabled only when the system is in 'Unrestricted' mode.
When engineer or manufacturer access has been allowed, the keypad displays the
text ENGINEER ENABLE or MANUFACT ENABLE. When access has been
granted, the user cannot access the system until the engineer has logged off.
To allow engineer access:
1. Scroll to GRANT ACCESS and press SELECT.
2. Select to ALLOW ENGINEER and select ENABLED.
3. Select to ALLOW MANUFACT. and select ENABLED.
4. To disallow engineer/manufacturer access, follow the same path and toggle to
DISABLED and press SELECT.
A6V10209178
26.09.2011