Appendix; User Rights - Siemens SPCK 420 User Manual

Appendix

7

User rights

7 Appendix
7.1
30
Siemens AB
Security Products
User rights
Based on the operational features of the SPC system, described below, users have
rights attributed to the user profiles. The installation engineer will inform users of
their user rights assigned to each user profile. Depending on how the system has
been programmed, users may have rights to all or some of these features.
User rights
User Profile User type
Default
Fullset Limited
Standard
Manager
Partset A Standard
Manager
Partset B Standard
Manager
Forceset Standard
Manager
Unset Limited
Standard
Manager
Restore Standard
Manager
Description
The FULLSET [➙ 15] operation fully sets the alarm
system and provides full protection to a building
(opening of any alarm zones activates the alarm).
On selecting FULLSET, the buzzer sounds and the
keypad display counts down the exit time period. Exit
the building before this time period has expired.
When the exit time period has expired, the system is
set and opening of entry/exit zones starts the entry
timer. If the system is not Unset before the entry timer
expires, the alarm is activated.
The PARTSET A [➙ 16] option provides perimeter
protection to a building while allowing free movement
through the exit and access areas.
Zones that have been classified as EXCLUDE A
remain unprotected in this mode. By default, there is no
exit time; the system sets instantly on selection of this
mode. An exit timer can be applied to this mode by
enabling the Partset A timed variable.
The PARTSET B option applies protection to all zones
except those that have been classified as EXCLUDE B.
By default there is no exit time; the system sets
instantly on selection of this mode. An exit timer can be
applied to this mode by enabling the Partset B timed
variable.
The FORCESET [➙ 16] option is presented on the
keypad display when an attempt is made to set the
system while an alarm zone is faulty or still open (the
top line of the display shows the open zone).
Selecting this option sets the alarm and inhibits the
zone for that set period.
The UNSET [➙ 15] operation unsets the alarm. This
menu option is only presented on the keypad after an
alarm has been activated and a valid user code has
been entered.
The RESTORE [➙ 16] operation restores an alert
condition on the system and clears the alert message
associated with that alert condition.
An alert condition can only be restored after the zone(s)
or fault(s) that triggered the alert condition have been
restored to their normal operating state and the
A6V10209178
26.09.2011