Sms; Sms Control; Sms Events - Siemens SPCK 420 User Manual

User programming via the keypad
6
User Menus
6.2.10
24
Siemens AB
Security Products
NOTICE
Where USER DURESS feature is enabled, consecutive user codes (i.e. 2906,
2907) are not permitted, as entering this PIN from the keypad would activate a
user duress event.
NOTICE
Engineer PINs should be noted down. If a PIN is forgotten, a factory default of the
system is required to reset PINs.

SMS

The SPC system support SMS communication from the panel to selected users'
mobile phones as well as users being able to control the SPC system remotely via
SMS. These two features work hand in hand as it allows the user to take action
using the SMS control after a SMS notification without the need to be physically at
the premises.

SMS control

The SMS control can be set up so that a remote user can send a SMS message to
perform the following actions at the panel:
Setting / unsetting

Enable / disable engineer

Enable / disable manufacturer access.

Mapping gate on/off.


SMS events

The SMS notification can be set up to send a range of events that occur on the
system such as:
Alarm activation

Confirmed alarms

Fault & tamper

Setting & unsetting

Inhibit & isolate

All other types of events

The SMS notification can operate with a PSTN modem if the PSTN operator
supports SMS over PSTN where as SMS control will need a GSM modem at the
panel. A GSM modem will support both SMS notification and control.
A6V10209178
26.09.2011