Assembly - MK Diamond Products MK-2000 SERIES Owner's Manual & Operating Instructions

UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY

ASSEMBLY:

Follow the assembly instructions in this section to prepare your MK-2000 for operation.
1. Releasing Cutting Head:
The following actions will cause the Cutting Head to rotate upward, hold the saw by the handle and
control the upward movement.
NOTE: The Cutting Head is locked in the down position when shipped from the factory.
Locking Handle
(A)
Remove Cutting Head Locking
Handle from shipping location
discard the Shipping Nut
2. Movable Cutting Table Installation:
Cutting Table Front
Roller Wheels
(A)
While holding the front, position
Movable Cutting Table Roller
Wheels above Guide Rails
3. Adjustable Cutting Guide Installation:
NOTE: The Adjustable Cutting Guide can be used on either side of the Diamond Blade.
Turn counter-
clockwise to loosen
(A)
Loosen Adjustable Cutting
Guide retaining thumbscrew
MK-2000
Turn counter-
clockwise to
loosen
9/16-inch
Shipping Bolt
wrench
Remove Shipping Bolt from the
Cutting Head – discard
Shipping Bolt
Guide Rail Roller Wheels
Seat Movable Cutting Table
Roller Wheels on Saw Guide
Position Adjustable Cutting
Guide above Movable Cutting
Revision 03/05, Effective Date March 21, 2005
9/16-inch
wrench
(B)
Guide Rails
(B)
Rails
Align
Parallel Slots
Ruler/Stop
(B)
Table
Turn clockwise
Height
to tighten
Adjusting Bar
Locking Handle
(C)
Install Locking Handle through
the Cutting Head Adjusting
Bar and into the Height
Adjustment Stud
Move back and forth to
verify ease of movement
(C)
Verify Movable Cutting Table is
seated correctly
Turn clockwise
to tighten
(C)
Seat and tighten the Adjustable
Cutting Guide retaining
thumbscrew
Seated
Page 13