MK Diamond Products MK-2000 SERIES Owner's Manual & Operating Instructions page 32

MAINTENANCE AND TROUBLESHOOTING
Direction of push
(J)
Push the Motor forward to
loosen the V-belt
Belt Seated
(M)
Verify the V-belt is seated in the
grooves of both pulleys
Continue Adjustment
Until Correct
(P)
Repeat steps N and O until
proper V-belt tension is achieved
MK-2000
Remove the old V-belt
Adjustment
Pulley
Strap Bolt
Rotate clockwise
to tighten
Tighten the Motor Adjustment
Strap using a 9/16-inch wrench to
remove slack
Retaining
Bolt
Rotate clockwise
to tighten
Tighten the Motor Mounting
Bolts using a 1/2-inch Wrench
Revision 03/05, Effective Date March 21, 2005
Old V-belt
(K)
Install the new V-belt MK Part
9/16-inch
Wrench
(N)
1/2-inch
Wrench
clockwise to loosen
(Q)
New V-belt
(L)
Number, 158194
Check Tension 1/2-
way between pulleys
(O)
Check the V-belt for proper
tension if the tension is
correct, go to step R (Proper
tension 1/8-inch deflection)
1/2-inch
Wrench
Rotate counter-
(R)
Install the Belt Guard
Page 32