MK Diamond Products MK-2000 SERIES Owner's Manual & Operating Instructions page 21

SETUP, ADJUSTMENT and OPERATION
Adjustable
Cutting Guide
Measuring
point
(D)
Set the Adjustable Cutting Guide
to the desired length indicated
on the side of the Ruler/Stop
closest to the Wooden Strip
ON/OFF
Switch
(G)
Place the ON/OFF Switch in
the ON position
Hold in
position
(J)
Move the Cutting Table to
position the Masonry Piece in
front of the Blade
ON/OFF
Switch
(M)
Turn the Saw off when cutting
is complete
MK-2000
Ruler/Stop
Ruler
Markings
Place the Masonry Piece onto
the Movable Cutting Table
OFF
Position
Control Valve
Open the Cooling Flow Control
Valve and adjust cooling flow
Push slowly to cut
Move into
position
Slowly push piece into the
blade until cutting begins
OFF
Position
Revision 03/05, Effective Date March 21, 2005
Masonry Piece
Cutting Guide
(E)
seated against the Ruler/Stop
and the Adjustable Cutting Guide
Cooling Flow
(H)
until cutting complete
(K)
Continue to push the Masonry
Adjustable Masonry Piece
Ruler/Stop
(F)
Verify the Masonry Piece is
Points
(I)
Verify cooling flow exists on
both sides of the blade
Continue pushing
(L)
Piece into the Blade until the
cut is complete
Page 21