MK Diamond Products MK-2000 SERIES Owner's Manual & Operating Instructions page 30

MAINTENANCE AND TROUBLESHOOTING
7. Protective Wooden Strip Replacement:
The protective wooden strip is to protect the Movable Cutting Table from damage during operation. Over
time, the wooden strip will become grooved from use. A grooved wooden strip will not support masonry
during cutting causing the blade to "break through" the piece instead of performing a smooth cut (MK
Diamond Part No. – 156427).
(A)
Remove the Movable Cutting
Table
Worn Wooden
Strip
New Wooden
Strip
(D)
Replace the worn Protective
Wooden Strip with the new
Protective Wooden Strip
8. Changing Voltage Setting:
Perform the following steps to change the voltage setting between 115v and 240v.
The power must be removed from the saw before changing the voltage setting.
Flat Blade
Screwdriver
Voltage
Change Switch
(A)
Remove the Voltage Change
Switch Locking Screw using a
Flat Blade Screwdriver
MK-2000
Movable
Cutting Table
Place the Movable Cutting
Table on a Workbench with the
Roller Wheels facing up
Place the Movable Cutting Table
on a Workbench with the Roller
Wheels facing up and reinstall
the Retaining Screws
Locking
Screw
Move Switch
Move the Voltage Change
Switch to the desired voltage
Revision 03/05, Effective Date March 21, 2005
Roller Wheels
(B)
Phillips
Screwdriver
Retaining Screw
(E)
(B)
setting
Phillips
Screwdriver
Retaining Screw
(C)
Remove the two Protective
Wooden Strip Retaining Screws
using a Phillips Screwdriver
Movable
Cutting Table
(F)
Remove the Movable Cutting
Table
(C)
Reinstall the Locking Screw
Locking
Screw
Page 30