MK Diamond Products MK-2000 SERIES Owner's Manual & Operating Instructions page 28

MAINTENANCE AND TROUBLESHOOTING
5. Diamond Blade Change-out:
NOTE: When installing the diamond blade retaining-bolt, ensure the threads of the bolt are aligned with the
threads of the drive shaft so as not to "cross-thread" the bolt.
Turn counter-
clockwise to loosen
Locking Handle
(A)
Loosen the Cutting Head
Locking Handle
Remove
the Blade
(D)
Remove the old Diamond Blade
Rotate the Blade
Wrench clockwise
to tighten
Retaining Screw
and Outer Flange
(G)
Install the Retaining Screw and
Outer Flange and then tighten
MK-2000
(B)
Raise Cutting Head to the
highest position and tighten the
Locking Handle
Install the
Blade
(E)
Install the new Diamond Blade
onto Blade Shaft
Revision 03/05, Effective Date March 21, 2005
Blade Wrench
Cutting Head
raised
Identify and remove Retaining
Screw and Outer Flange using
the Blade Wrench
Rotation
Direction
Verify the Blade is seated on the
Blade Shaft and the Directional
Arrows are facing out
Retaining Screw
and Outer Flange
Turn counter-
clockwise to
loosen
(C)
Seat Blade on
Blade Shaft
(F)
Page 28