MK Diamond Products MK-2000 SERIES Owner's Manual & Operating Instructions page 17

SETUP, ADJUSTMENT and OPERATION
4 MK-2000 Setup for Operation:
1. Before powering or starting, check for damage that could prevent this equipment from proper
operation or performing it's intended function. Check for binding and alignment of moving parts.
Check for damaged, broken, or missing parts.
2. Verify the On/Off switch is in the OFF position.
3. Before connecting the MK-2000 to a power supply, be sure the voltage, cycle and phase of the
job site power source meet one of the requirements of TABLE 3
4. If using an extension power cord, make sure the length and wire gauge correspond to he
requirements listed in TABLE 1 on page 9. An extension power cord that is too small in wire
gauge (diameter), or too long in length, will cause the motor to overheat and could cause
premature failure.
5. Do not cover the motor vents as this could lead to motor overheating.
NOTE: In order to avoid breaker tripping, a 20-amp circuit breaker should be used.
Portable Generator:
If using a portable generator to provide power, ensure the generator meets the following minimum
requirements:
8 KW
FOR DUAL VOLTAGE MODELS ONLY ! The MK-2000 motor has 2 voltage positions, 115v and
240v. Ensure the Voltage Adjustment Switch of the MK-2000 motor is set for the voltage of the
intended power source BEFORE installing the MK-2000 Power cord.
ON/OFF
Switch
(A)
Ensure the ON/OFF Switch is
in the OFF position
Turn clockwise
(D)
Align, install and twist to lock the
Polarized plug of the MK-2000
into the correct power source
MK-2000
VOLTAGE:
CYCLE:
PHASE:
TABLE 3
120/240 volts
OFF Voltage Adjustment
Position Switch
Verify or place the Voltage
Adjustment Switch in the correct
voltage position (See the
Maintenance Section)
to lock
Revision 03/05, Effective Date March 21, 2005
115v/240v
60hz
1-phase
66.7/33.3 amps
(B)
Locate the correct power source
Single Phase
115v Power 240v Power
Source Source
(C)
for the setting of the MK-2000
Voltage Adjustment Switch
Page 17