Table of Contents
Advertisement
Installation Instructions
Thermostat Model and Part Number
Daikin offers two different 7-Day Programmable Digital
Heating/Cooling Thermostat with constant fan or Fan cycled,
On/Off Valve Control depending on the fan speed control
used (See
Table
2).
.
Table 2: Thermostat Model and Part Number
Model
Part
Number
Number
TA180-001
910119110
TB180-001
910119111
Optional Sensors/Kits
In addition to the T180 thermostat, Daikin offers optional
sensors for occupancy detection
10K pipe sensor
page
12) that can be ordered and used in
conjunction with the thermostat. Use the associated kit
number(s) provided in
Table 3
Table 3: Sensor Model and Kit Numbers
Sensor Model Number
SB200-001
Occupancy
Detection
SD200-001
Sensor
SD200-002
10K Pipe Sensor
Installing, Mounting and Wiring
the Thermostat
The thermostat should be used indoors only. It should be
mounted on an inner wall in a location with freely circulating
air, and where it will be responsive to changes in room
temperature. Avoid mounting near heat generating appliances
(i.e. TV, heater, refrigerator), or in direct sunlight.
The thermostat base mounts to a field provided 4" × 4" outlet
box with a 2" × 4" horizontal mud ring. The thermostat cover
assembly mounts to the thermostat base.
.
Before applying power, the voltage selection switch must be in
the appropriate position. Failure to select the correct voltage
can cause thermostat malfunction or permanently damage the
thermostat.
To use a remote sensor on units with local sensing capability,
remove jumper JP1 to disable local sensing. Failure to remove
JP1 can cause improper operation of the thermostat with a
remote probe installed.
4
Fan Speed Control
3-speed fan control
Staged fan control
(page 14
and
page
15) and
when ordering.
Daikin Part Number
6677877311
6677877411
6677877511
107201601
CAUTION
CAUTION
CAUTION
• Use copper wire only. Insulate or wire nut all unused leads.
• Avoid electrostatic discharge to the thermostat.
• Failure to do so can cause thermostat malfunction or
permanently damage the thermostat.
Hazardous voltage. Combined load current is not to exceed 20
amps. Mount only to a grounded metallic box.
Low voltage wiring is Class 2. To avoid electrical shock or
Damage to equipment, disconnect power before installing or
servicing. Failure to follow these instructions will result in death
or serious injury
1
Disconnect power before installing or servicing.
2
Run line voltage wiring (and low voltage wiring if
applicable) into the field provided outlet box and mud
ring
(Figure
2).
Locate all connections within the mud ring/connection
3
box and wire nut all unused wires.
Remove the thermostat cover assembly from its base to
4
gain access to the circuit board
Figure 2: Mounting the Thermostat
Figure 3: Circuit Board
DANGER
(Figure
3).
Daikin IM 1019
Advertisement
Table of Contents
