Table of Contents
Advertisement
28
GE 16X PTZ Camera
User Manual
Alarm menus
The GE 16X PTZ camera has a terminal that can sense the alarm signals. The camera can be programmed to go
to a preset with a signal from any connected alarm device.
Setting alarms
To set an alarm, do the following:
1. From MAIN MENU, select ALARM MENU
(Figure 55).
2. From ALARM MENU, select ALARM1 or
ALARM2 (Figure 56).
3. Select NORMAL OPEN to activate the
alarm in the close position.
4. Select NORMAL CLOSE to activate the
alarm in the open position.
5. Select DISABLE to disable the alarm.
Note: The mapping between preset position and alarm is
fixed and not programmable.
When alarm1 is triggered, preset1 is activated. When
alarm2 is triggered, preset2 is activated. The presets run
continuously until alarm source is off.
If the corresponding preset is not programmed no alarm
action can be executed.
Figure 55. MAIN MENU
Figure 56. ALARM MENU
Figure 57. ALARM 1 menu
PRESET1
Advertisement
Table of Contents
