Zoom End Position Setting; Flickerless Setting - GE 16X PTZ User Manual

20 GE 16X PTZ Camera
User Manual

Zoom end position setting

You may set the zoom end position of the camera. When you use the zoom feature, the zoom will always end at
the selected zoom end position.
To set a zoom end position, do the following
1. From MAIN MENU, select CAMERA
MENU.
2. From CAMERA MENU 2, select ZOOM
END (Figure 38).
3. On ZOOM END, enter a zoom end position
from X2 to X128 (Figure 39).
4. Use the number buttons or joystick (up and
down) to set the zoom end position.
Note: If you set the zoom end position less than the zoom
start position, the zoom end position is automatically set to
one higher than the zoom start position (zoom end position
= zoom start position + 1).

Flickerless setting

To remove the flicker in the picture caused by fluorescent lighting, do the following:
1. From MAIN MENU, select CAMERA
MENU.
2. From CAMERA MENU 2, select
FLICKERLESS (Figure 40).
:
Figure 38. CAMERA MENU 2
Figure 39. ZOOM START menu
Figure 40. CAMERA MENU 2