Bounty Hunter Time Ranger Owenrs Manual page 23

1. Perform the steps described in Turning the Detector ON section of
this manual.
2. Press the DISC TARGET touch pad.
A blinking arrow appears under IRON/FOIL in the Probable
Target ID fields, meaning the detector is ready for programming.
3. Press the HIGH (+) SENSITIVITY touch pad on the control panel
to adjust the detector's sensitivity to 7 (default setting is 5).
4. Press the SNIFF touch pad and verify that SNIFF appears in the
TARGET readout on the LCD display, as shown in the following
diagram.
To accept only one desired target from the Target ID field
(while in SNIFF mode)
1. Sweep the coil over an object identical/similar to the object you
want to accept.
An arrow appears under one of the Target ID fields.
2. Verify that the arrow points to the Target ID field you want to
accept and press the ACCEPT (+) TARGET touch pad on the
control panel.
Ac appears in the TARGET readout on the LCD display. A
"sniff window" based on the object's target value is created.
3. Verify that the target value was properly set by sweeping the coil
over the target object one more time.
The arrow should appear under the same Target ID field in Step 1.
4. Proceed with your search for the one particular target—all other
target indications will be rejected.
To reject only one desired target from the Target ID field
(while in SNIFF mode)
1. Sweep the coil over an object identical/similar to the object you
want to reject.
An arrow appears under one of the Target ID fields.
POWER
SNIFF
ON/OFF
ALL METAL
SMART
TRAC
DISC
PRESET
TARGET
BLANKER
20