Throttle Mode; Brakes - Wisper 705se Owner's Manual

pedelec mode you must keep turning the pedals, if you stop pedaling the motor
will stop and the bike will slow to a halt. If you start pedaling again after one
turn the motor will start again.
12.2 You will find the ASSIST button on the panel on the handle bars with 6
associated LEDs (small lights). Each time the button is pressed the LEDs
illuminate sequentially ranging between 1 and 6 and the corresponding power
level in pedelec mode increases in increments of 20%. Setting 6 provides 100%
power.
12.3 Setting 6 is generally used when you need the maximum amount of assistance
from the motor. Lower settings are used when you do not need the instant
100% power, high traffic situations or poor conditions such as ice and snow
when full power immediately could be dangerous. Power settings can be
changed when the bike is stationary or when on the move.
13

Throttle mode

13.1 The throttle can be used independently to the pedelec mode but the operation
will vary depending on the country where the bike is supplied. Bikes are set up
to be legal in the region in which they are supplied and will either provide full
power (100%) or power up to 4 mph (6kph) (walkalong mode) independently of
the pedelec.
13.2 The independent use of the throttle, when available, will enable you to use the
throttle without pedaling.
13.3 The use of the throttle in pedelec mode is legal in most countries. Throttle in
pedelec mode enables you to apply the power to the motor as long as you are
pedaling the bike, if you stop pedaling the motor will stop too. If you have the
pedelec mode set too low, you can increase the assistance from the motor by
turning the throttle towards you.
IMPORTANT Make sure your throttle and handlebar grips are always intact and in good
condition. Uncovered handlebar tubes can be very dangerous.
14

Brakes

14.1 Front: Disc brake
14.2 The brakes on your Wisper bike are fitted
with cut outs which are required by law.
This means that when you pull on either the
back or front brake lever the motor
immediately stops working.
14.3 Regularly inspect brake pads for wear.
Replace brake pads if the grooves are no
Rear: V brake
- 12 -