Optional Accessories Requirements - Heat & Glo GRAND-I35-C Owner's Manual

D. Optional Accessories Requirements
• This appliance may be used with a wall switch, wall
mounted thermostat and/or a remote control.
• To connect optional accessories, the supplied cord as-
sembly should be used. See attached Figure 10.4 for
a wiring diagram for a blower or remote.
Wiring for optional Hearth & Home Technologies approved
accessories should be done now to avoid reconstruction.
Follow instructions that come with those accessories.
• Plug the cord into a convenient outlet.
• Must use cord supplied.
NOTE: IF ANY OF THE ORIGINAL
WIRE AS SUPPLIED WITH THE
APPLIANCE MUST BE REPLACED,
IT MUST BE REPLACED WITH TYPE
105 C RATED WIRE.
0
NOTE: USE ZIP TIES TO RESTRAIN
THE LOOSE WIRES UNDERNEATH
THE APPLIANCE AND KEEP THEM
AWAY FROM THE BLOWER WHEEL
(FAN BLADES).
VARIABLE SPEED
CONTROL
BLK
BLK
BLK
BLK
TEMPERATURE
SENSOR SWITCH
Figure 10.4 Fan Wiring Diagram
30 Heat & Glo • Grand-I35-C, Grand-I35-SP, Supreme-I30-C, Supreme-I30-SP • 2206-901 Rev. P • 6/14
BLOWER
PLUG INTO 120V
EXISTING OUTLET
DC REGULATOR
RECEPTACLE
BLOWER
RECEPTACLE
• An IntelliFire™ Plus Wireless Controls or WSK-21
wired wall switch may be used with the IntelliFire™
Plus Ignition System. Hearth & Home Technologies
recommends that IntelliFire Plus™ wireless controls be
used for their features and functionality with the Intel-
liFire™ Plus ignition system.
• A standard ON/OFF switch is compatible.
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105° C rated wire. Wire must have high temperature
insulation.
TEMPERATURE
SENSOR SWITCH
TO VALVE BRACKET
(GROUND)
GREEN
ORANGE
TO VALVE
BROWN
BLACK
RED
WHT
GRN
BLK
GRN
WHT
PLUG
120V EXISTING
OUTLET
SPEED CONTROL
(RHEOSTAT)
BLK
GRN
BLK
FUSE WIRE
ASSEMBLY
FUSE WIRE
ASSEMBLY
BLK
BLK
GRN
BLK
BLOWERS