Interface
error
Card
removal
error
Paper
size
error
Paper
size
error
Jam
errors
An error occurred in the
serial I/F.
This message is displayed
when a parity error, a framing
error or an overrun error is
detected.
The card containing print
data was removed.
Paper of improper size was
fed from the tray.
tttttt: MANUAL, TRAY 1,
TRAY 2 or ENVLOP
A jam occurred during paper
feeding from the tray.
tttttt: MANUAL, TRAY 1,
TRAY 2 or ENVLOP
A jam occurred during paper
feeding from the tray.
tttttt: MANUAL, TRAY 1,
TRAY 2 or ENVLOP
- Press the RECOVER
key on the operator panel
to release the error
display.
- Check the settings of
RS232C I/F in the menu.
- Replace the interface
cable or Control board.
Note: When replacing the
Control board, install the
EEPROM mounted in the
replaced Control board.
- Install the card again.
- Check the paper in the
tray or check to see if
more than one sheet of
copy were fed
simultaneously.
- Open the cover, then
close it to perform
recovery printing and the
error display is released.
- If this error occurs
frequently,
see chapter
6.5.2.
- Check the paper in the
cassette. Open the
cover, then close it to
perform recovery printing
and the error display is
released.
- If this error occurs
frequently,
see chapter
6.5.2.
- Check the paper in the
cassette. Open the
cover, then close it to
perform recovery printing
and the error display is
released.
- If this error occurs
frequently,
see chapter
6.5.2.