Table of Contents
Advertisement
The page below describes the detail connection information with each station.
You can get all information needed right here.
System Configuration –
Now you can start to configure the system. In System Properties page, you
can config
Device Name – You may assign any name to the Access Point.
Memorable, Unique names are helpful especially if you are employing
multiple access points on the same network. The device name needs to be
less than 32 characters. After verify the name you input and click "Apply"
to save the setting.
Operation Mode - The default operation mode is Access Point, this
connects your wireless PCs and devices to a wired network. In most cases,
no change is necessary. You can switch operation mode to Wireless Client
or Repeater or Bridge mode depends on your application. Wireless Client
mode can allow AP act as a client within its range. Your Ethernet devices
behind the AP can connect to remote AP. Repeater is able to talk with one
remote access point within its range and retransmit its signal. Choose
repeater mode if you want to extend the range of your original AP. Wireless
Bridge (WDS) can allow Bridge point to point or point to multi-point
16
Advertisement
Table of Contents
