System Overview
WAB-3003
1
Power
2~3
Wireless Signal Strength
4
WLAN
5
Wireless Signal
Strength
6
Ethernet
7
RJ – 45 PoE Connector
8
N-type Connector
9
Reset Button *(Screw)
Reset Procedure
1. Make sure the WAB-3003 completes booting and is already running
(The booting process of system usually takes 2 minutes)
2. *Unscrew the Screw then you will see a reset button (inside the hole)
3. Use the provided reset pin to press and hold the reset button for 15 seconds
4. Release the reset button and leave the system re-booting for 2 minutes
Red LED ON indicates Power on, and OFF indicates power off
For showing the signal strength situation (7: Yellow; 8: Green)
Green LED ON indicates system ready
For showing the signal strength situation
Green LED ON indicates connection, OFF indicates no
connection, and BLINKING indicates transmitting data.
For connecting to the Power Sourcing Equipment (PSE)
For connecting to an antenna
For resetting the system of AP
2