Table of Contents
Advertisement
AP Configuration Using Locator
While entering the Locator utility, the Locator will automatically search the
available WAP-1001 on the same network. Locator will show the Device Name,
Device Type, IP Address, Ethernet MAC Address and Firmware Version in first
page. Before start using Locator, make sure you disable personal firewall
installed in you PC. (Ex. Windows XP personal firewall)
If you have 2 Fast Ethernet Adapter or more, you can choose enable one Fast
Ethernet Adapter for enter with Locator utility.
AP Configuration Using Web User Interface
Before Setup...
Verify the IP address setting
You need to configure your PC's network settings to obtain an IP address.
Computer use IP addresses to communicate with each other across a network,
such as the Internet.
1.
From the taskbar, click the Start button, select Settings > Control
Panel. From there, double-click the Network connections icon.
2.
Right click the Local Area Connection icon Properties; select the
TCP/IP line for the applicable Ethernet adapter. Then, click the
Properties button.
3.
Click the IP Address tab page, select USE the following IP
address, type
192.168.1.20
in the IP Address field and 255.255.0.0 in the Subnet Mask field,
then click OK button.
Start Setup by Browser...
1.
After getting the correct connection, start the web browser (make
sure you disable the proxy) and type
of outdoor AP ip Address)
192.168.1.X
(X can be from 1 to 254,but
is for WAP-1001 already, please avoid the confliction)
in the Address field. Press Enter.
11
192.168.1.20 (The default IP
Advertisement
Table of Contents
