Table of Contents
Advertisement
Quick Reference guide
①
Before using the In-Stud
fireplace verify:
• Are the circuit breakers for the
unit on?
• Are the light bulbs loose? (To
check, follow the instructions
for replacing the light bulbs
under the maintenance section
of this manual)
Fireplace Installation
!
NOTE: A 10 Amp, 240 Volt
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A
dedicated circuit will be
required if, after installation,
the circuit breaker trips or the
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
CAUTION: The heater must
not be located immediately
above a socket outlet.
6
②
The heater may emit a slight,
harmless odor when first used.
This odor is a normal condition
caused by the initial heating of
internal heater parts.
③ The information regarding the
model of your unit can be found
on the model and serial number
plate located on the side of the
unit. See Page 3 for an illustration
on how to locate the rating plate.
WARNINg: Ensure the power
cord is not installed so that it is
pinched or against a sharp
edge and ensure that the
power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
fire, electric shock or injury to
persons.
Construction and electrical
outlet wiring must comply with
local building codes and other
applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
www.dimplex.com
Advertisement
Table of Contents
