Table of Contents
Advertisement
Fireplace Installation
Use the appropriate wire
to meet local and national
electrical codes for rated
power consumption.
Means for disconnection must
be incorporated in the fixed
wiring.
④
Remove the outer jacket and
strip the individual conductor from
the end.
⑤
Loosen the screw securing
the junction box cover and
remove the cover.
⑥
Take the cables out from the
junction box, loosen the terminal
block and remove the cord set
(Figure 5).
Figure 5
⑦
Route the power supply wire
through the knockout on supplied
alternative junction box cover
Figure 6
and secure with a wire clamp (not
supplied).
⑧
Connect the live wire from the
unit to the live wire from power
supply (Figure 6).
⑨
Connect the neutral wire from
the unit to the neutral wire from
power supply (Figure 6).
⑩
Connect the green wire
(ground) from the unit to the
green wire from power supply
(Figure 6).
⑪
Place all connectors inside
the unit and secure the junction
box cover to unit. Ensure that the
cable clamp grips only the jacket
of service cable.
!
NOTE:
All wiring must be
completed prior to installing
11
Advertisement
Table of Contents
