Page 1
Opti-V. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.com 7213460100R04...
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. W ARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of ire, serious injury, or death. www.dimplex.com...
Welcome & Congratulations Thank you and congratulations for purchasing an Opti-V from Dimplex. Please use our convenient online registration page to record your model and serial numbers for future reference at www.dimplex.com/register Model Number MODEL 6909410100 MADE IN IRELAND MODELE...
(including ampliiers) that damaged cord, or if the Opti-V produce heat. has been dropped or damaged in any manner, contact Dimplex 10. No naked lame sources, such as Technical Service at candles should be placed on this 1-888-346-7539. apparatus.
IMPORTANT SAFETY INSTRUCTIONS only as described in this manual. NOTE: To disconnect from mains Any other use not recommended - set the mains switch to 'O'. The by the manufacturer may cause mains (power) switch is located at ire, electric shock or injury to the top left hand side of the appliance persons.
NOTE: Please read all instruc- viewers enjoyment is important. It tions before installing. is recommended that the follow- 1. For rough in framing, the ing guidelines be used for locating opening should follow the the unit. www.dimplex.com...
Page 7
120-240VAC. VF2927L / VFA2927 - 63 lbs (29 kg) VF5452L - 116 lbs (52 kg) NOTE: Use minimum 14 AWG supply cable with two insulated 2. Allow up to 4 ft. (121.9 cm) of...
Page 8
Line 2 (240V) from the 5. Place the unit in the framed power supply using a wire opening, level with shims if connector (included). Figure 2 Figure 3 Cable Clamp Hole Grounding Screw Cable Plate Electrical Mounting Cover Panel Flanges www.dimplex.com...
Page 9
Opti-V Installation 13. Finish surrounding wall. NOTE: Cap any additional There are 3 different options wires from the power supply not for inishing the wall: used in the installation. • Permanent - install drywall 9. Ensure that the green ground- right up to the lange that sur- ing wire is securely attached rounds the opening.
The screen brightness can be ad- top left hand side of the appliance justed using the (Figure 2E) above the glass. (Figure 2) buttons. The but- (Figure 2F) The mains (power) switch (Figure ton darkens the screen and the www.dimplex.com...
Page 11
Operation Figure 3 button brightens the screen. Volume Battery ! NOTE: On the VF5452L there Controls Cover are brightness controls for each LED screen. The brightness controls for the right screen are located in the center of the unit. Remote Control Operation...
Opti-V Surface Cleaning To remove ingerprints or other marks, the exterior inish can be cleaned with a damp cloth with a mild detergent. The surface should be completely dried with a lint free cloth to prevent water spots. www.dimplex.com...
Limited warranty service requires a proof how long of purchase of the product. Products, other than surrounds (mantels) What Dimplex will do in the event of a and trims, covered by this limited warranty defect have been tested and inspected prior to...
Page 14
Warranty repair or replace such defective prod- replacement product or part) including, uct or part without charge. If Dimplex without limitation, all shipping costs is unable to repair or replace such and transportation costs to and from product or part, or if repair or replace- the authorized dealer’s or service...