Table of Contents
Advertisement
Quick Links
IMPORTANT SAFETY INFORMATION: Always read this manual first
before attempting to install or use this fireplace. For your safety, always
comply with all warnings and safety instructions contained in this manual
to prevent personal injury or property damage.
Owner's Manual
Model
VCX1525-EU
7209960100rev00
Advertisement
Table of Contents
Related Manuals for Dimplex VCX1525-EU
Summary of Contents for Dimplex VCX1525-EU
- Page 1 Owner’s Manual Model VCX1525-EU IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this fireplace. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage.
-
Page 2: Table Of Contents
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. W ARNINg: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com... -
Page 3: Welcome & Congratulations
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric NO NEED TO RETURN fireplace from Dimplex, the world TO THE STORE leader in electric fireplaces. Questions With the Assembly? Please carefully read and save these instructions. -
Page 4: Important Safety Instructions
Do not run the cord under cord. Extension cords may overheat carpeting (for units supplied with a and cause a risk of fire. If you must cord). Do not cover cord with throw use an extension cord, the cord must www.dimplex.com... -
Page 5: Save These Instructions
IMPORTANT INSTRUCTIONS be 3-core type and rated no less than place, free from excessive vibration 10 Amps. and store so as to avoid damage. ⑮ Do not put combustible material, Do not burn wood or other liquid, small articles such as sand materials in the fireplace. -
Page 6: Quick Reference Guide
CAUTION: The heater must shock and injury to persons. not be located immediately Do not attempt to wire your above a socket outlet. own new outlets or circuits. To www.dimplex.com... -
Page 7: Wall Mounting Instructions
Fireplace Installation Figure 1 reduce the risk of fire, electric shock or injury to persons, D E F always use a licensed electrician. WARNINg: The Convex In- Stud fireplace is wall mountable and can be built in a wall space 406 mm over- center between 2”... - Page 8 3 mm exposed threads for the already in the wall, leave 3 mm fireplace to hang on. exposed threads for mounting ④ The second mounting point fireplace. www.dimplex.com...
- Page 9 Fireplace Installation ⑦ ⑫ With the glass assembly Tighten both mounting screws taken off, mount the firebox onto with a screwdriver. Be careful not the two (2) mounting screws. to over tighten the screws mated with the drywall anchor. ⑧ Mark position of hole “H”.
- Page 10 This make the actual installation should be measurements for the wall entrusted to duly qualified opening. Dimplex will not be personnel where required by responsible for inaccuracies in law. the design or manufacture of enclosures.
- Page 11 Fireplace Installation Use the appropriate wire Figure 6 to meet local and national electrical codes for rated power consumption. Means for disconnection must be incorporated in the fixed wiring. ④ Remove the outer jacket and strip the individual conductor from the end.
-
Page 12: Bathroom Installation
Figure 7 Never locate fireplace where it may fall into a bathtub or other water containers. Keep towels wood and other combustible materials screws 0.9 m away from the bottom of here the unit. www.dimplex.com... -
Page 13: Operation
Operation Figure 8 Level 2: The flame effect remains on, the heater is activated to the low heat setting, and the first and second indicator light illuminates. Level 3: The flame effect remains on, the heater is set to the high heat setting, and all three (3) indicator lights illuminate. -
Page 14: Remote Operation
Remote Initialization Remote Operation Should your remote have difficulty The fireplace is supplied with a communicating with the remote radio frequency remote control. receiver, or should either the www.dimplex.com... -
Page 15: Maintenance
Operation Remote Control Usage remote or receiver board be replaced, you may need to The remote control operates the initialize the remote. fireplace levels sequentially (from From a powered off state: off): flames only; to flames and low heat; to flames and high heat. ①... - Page 16 ② Remove glass assembly. (Figure 10). Remove the screws securing the ④ Remove the two (2) screws glass assembly on the chassis securing the light block as shown (Figure 3). in Figure 11, then remove the light www.dimplex.com...
-
Page 17: Replacement Parts
Maintenance block. with a damp cloth. The glass should be completely dried with ⑤ Reach in and turn the burnt a lint free cloth to prevent water bulb(s) counterclockwise to spots. To prevent scratching, remove. do not use abrasive cleaners or ⑥... -
Page 18: Warranty
Warranty Dimplex Electric Fireplaces are tested and inspected prior to shipment and are guaranteed from defect to the purchaser of each new product. Any part which proves to be defective in material or workmanship under normal use within one year will be repaired or replaced without charge.* The Company will not be responsible for any... - Page 20 www.dimplex.com...