Setting The Installation Position For The Roll Paper Near-End Detector - Epson TM-L90 series Service Manual

Confidential

Setting the Installation Position for the Roll Paper Near-End Detector

This printer allows you to change the installation position for the roll paper near-end detector
using the following procedure. Set the detector based on whether your printer is installed
vertically or horizontally.
1. Loosen the detector adjustment screw with a coin or similar tool. Turn the screw at least 3 or
4 times.
2. Push the detector lever in until it touches the back of the hole.
3. While pushing the detector lever, turn the tab until the lever clicks into place in the desired
hole.
tab
Detector
adjuat screw
4. Secure the detector adjustment screw.
5. Make sure the detector lever moves smoothly.
Rev.B
TM-L90 Service Manual
Hole for vertical installation
or wall mount
Hole for horizontal
installation
Detector lever
Installation 6-3