Epson TM-L90 series Service Manual page 26

Confidential
3. Users may choose between partial cut and full cut by adjusting the autocutter unit to the
desired position. Check the part shown below to see if the autocutter is set to full cut or
partial cut. When you install the autocutter unit, return the unit to the user's position.
4. Remove the autocutter unit by removing the two S4 screws securing it. Stand the removed
autocutter unit against the front of the printer.
Rev.C
Dowel
S4
Autocutter unit
TM-L90 Service Manual
The dowel positions are marked
"F" and "P."
To select partial cut: adjust the
dowel to the position marked P.
To select full cut: adjust the dowel
to the position marked F.
Disassembly and Assembly 3-5