Attaching The Power Switch Cover - Epson TM-L90 series Service Manual

Confidential
4. Push the label paper spacer until you feel it click onto the shaft. Check that the label paper
spacer slides smoothly to the left and right.
5. Slide the label paper spacer to the appropriate width. You can use the ruler printed inside
the printer, aligning the inside edge of the spacer with the desired measurement.
Screw
6. Tighten the spacer with the screw included with the spacer. (See figure above.)
7. Set the NV memory for the desired paper width.

Attaching the Power Switch Cover

WARNING:
If an accident occurs when the power switch cover is attached, unplug the power
supply cord from the outlet immediately. Continued usage may lead to fire or shock.
You can use the power switch cover to make sure the power switch is not accidentally pressed.
Peel off the paper on the back of the power switch cover, and attach it as shown in the
illustration.
6-8 Installation
Ruler
Rev.B