Confidential
Chapter 5
Adjustment and Setting
Setting the Installation Position for the Roll Paper Near-End Detector
This printer allows you to change the installation position for the roll paper near-end detector
using the following steps.
1. Loosen the detector adjustment screw with a coin or similar tool. Turn the screw at least 3 or
4 times.
2. Push the detector lever in until it touches the back of the hole.
3. While pushing the detector lever, turn the tab until the lever clicks into place in the desired
hole.
Detector
adjustment screw
Detector lever
4. Secure the detector adjustment screw.
5. Make sure the detector lever moves smoothly.
Rev. B
TM-U220 Type A Service Manual
Adjustment and Setting 5-1