Epson TM-L90 series Service Manual page 51

Confidential
Label Paper Holder
1. Remove the lead wire of the LED holder assembly from between the center frame and the
front frame.
2. Remove the S1 screw.
3. Pull the label paper holder out straight along the grooves in the frame L assembly and
frame R.
S1
Front frame
Center frame
Install using the following steps:
1. Pass the lead wire of the LED holder assembly through to the front, between the center
frame and the front frame.
2. Press in and slide the label paper holder straight along the grooves in the frame L assembly
and frame R, until it hits the stop.
CAUTION:
When installing the label paper holder, do not pinch the cables.
3. Tighten the S1 screw.
3-30 Disassembly and Assembly
Frame L assembly
Label paper holder
Frame R
Rev.C