BLADEZ PB-SE802 Handbook page 9

7. Slowly open the GAS CAP, so that
possible over-pressure disappears.
8. Clean the tank cap area to make sure
that it is free from excess dirt and debris.
* Make sure that no dirt falls into the gas
tank.
9. Pour pre-mixed Gas/Oil mixture into the
GAS TANK. * Do not overfill.
10. After fueling, replace the GAS CAP and
tighten.
Starting
Move at least 10 feet away from where
you filled up the gas.
11. Set the CHOKE LEVER to the CHOKED
(UP) position. (Fig. 5)
12. Pull the RECOIL STARTER briskly,
making sure to hold the handle in your
grasp. (Fig. 6) * Note: Do not allow it to
snap back, let it back slowly. You may
want to give it a little throttle by gently
squeezing the GAS LEVER.
13. It may be necessary to repeat step 12
several times until the motor starts
When starting the MOBY for the first
time, it may be necessary to pull the
starter handle multiple times until it
starts.
*This is because the gas needs to be drawn
into the carburetor.
14. Once the engine has started, quickly
move the CHOKE LEVER into the RUN
(DOWN) position. (Fig. 5)
15. After engine is started, let it warm up for
2-3 minutes before riding.
IF THE MOTOR KEEPS STAHLING AT
IDLE SPEED, IT MAY BE NECSSARY TO
ADJUST THE IDLE SPEED ON THE
CARBURETOR.
Please refer to Carburetor Adjustment in the
Maintenance section on page 12 for
instructions on how to adjust idle speed.
Page 9 of 18