Maintenance; Recommended Tools; Carburetor Adjustment - BLADEZ PB-SE802 Handbook

Gas powerboard powered personal transportation
Table of Contents

Advertisement

MAINTENANCE

RECOMMENDED TOOLS

To adjust and service the Bladez MOBY Power Board you will need the following
tools:
Allen Wrenches:
Wrenches:
Short reach Spark Plug Socket
Large Adjustable Crescent Wrench
Spark Plug Sockets
Philips Head Screwdrivers
Oil, Grease or Lubricant (such as WD-40)

CARBURETOR ADJUSTMENT

WARNING!
Never start the engine without the complete clutch cover assembled!
Otherwise the clutch can come loose and cause personal injuries.
In the Carburetor, fuel is mixed with air. When the engine is test run at
the factory, the Carburetor is basically adjusted. A further adjustment
may be required from time to time, depending on climate and altitude.
The Carburetor has only one possible adjustment:
T= idle speed adjustment screw
Idle Speed Adjustment (Fig. 9)
When the idle speed is adjusted properly, the engine will run smoothly,
without pressing the THROTTLE LEVER.
3 / 4 / 5 / 6mm.
10 / 13 / 16 mm Open and ring combination.
If adjustment is required:
1. Start the engine.
2. Using a long, Philips head screwdriver
gently close (clockwise) the T-screw
until the MOBY starts to move forward.
3. Then open (counter-clockwise) the
screw until the MOBY stops.
4. You have reached the correct idle speed
when the engine runs smoothly below
the RPM when the MOBY starts to
move.
Note: Standard idle RPM is about 2500-
3000 RPM.
Page 12 of 18

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pb-se803Pb-se1802Pb-se1803Moby 35Moby 40

Table of Contents