Table of Contents
Advertisement
Connection to USB host port
The CT-6382T can be equipped with one high-speed USB2.0 host connection.
With software support, users can connect USB devices such as printers and a hard
disc to the CT-6382T. For this software release, printer server is supported.
Connection to Power
Connect the Power jack to the shipped power cord. Attach the power adapter to
the wall outlet or other AC source.
After all connections have been made, push the power-switch in to the on position.
After power on, the VoIP IAD performs a self-test. Wait for a few seconds until the
test is finished, then the VoIP IAD will be ready to operate.
Note: Restore the default parameters of the VoIP IAD by holding down the device's
Reset button until the LED's start blinking simultaneously (about 5 seconds). After
the device has rebooted successfully, and if the connection is established, the LAN
LED, ADSL LED will display in green, depending on the connection type.
Caution 1:
If the VoIP IAD fails to power up, or it malfunctions, first verify that the
power supply is connected correctly. Then power it on again. If the
problem persists, contact our technical support engineers.
Caution 2:
Before servicing or disassembling this equipment always disconnect all
power cords and telephone lines from the wall outlet.
10
Advertisement
Table of Contents
