Final Assembly; Warning - Emerson BRADSHAW CF890BS00 Owner's Manual

6.1
Lift the ceiling cover up to the threaded studs and turn
until studs protrude through the holes in the ceiling
cover (Figure 17).
6.2
Secure the ceiling cover in place by sliding lockwashers
over the threaded studs and installing the two knurled
knobs (supplied). (Figure 17). Tighten the knurled
knobs securely until the ceiling cover fits snugly against
the ceiling and the hole in the ceiling cover is clear of
the downrod.

WARNING

!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
6.3
Screw in two 50-watt (maximum) halogen base bulbs
(supplied) in the light kit assembly sockets (Figure 18).
6.4
Place the glass bowl into the opening in the lower
housing assembly, aligning the three flat areas on the
top edge of the glass with the three raised dimples on
the lower housing assembly and turn the glass bowl
clockwise until it stops (Figure 19).
NOTE: periodically check that the glass bowl is
seated fully clockwise in the lower housing
assembly.

6. Final Assembly

Figure 17
LIGHT KIT
ASSEMBLY
SOCKET (2)
Figure 18
Figure 19
12
CEILING COVER
THREADED STUDS (2)
LOCKWASHERS (2)
KNURLED KNOBS (2)
50-WATT
(maximum)
HALOGEN BASE
BULBS (2)
LOWER
HOUSING
RAISED
DIMPLES (3)
FLAT
AREA
GLASS
BOWL
ETL Model No.: CF890