SmartNode 4830 DSL Series User Manual
•
Enter PPPoE mode and define a PPP session if the provider is using PPPoE.
Note
Setting up permanent virtual circuits (PVC)
The modems currently available are using ATM to multiplex traffic over the DSL framing connection. ATM
allows you to have separate logical connections running in parallel. Those connections are called permanent
virtual circuits (PVC). All permanent virtual circuits use AAL5 framing.
Step 1
node(prt-dsl)[0/0]# [no] pvc vpi 8 vci 35
Step 2
node(pvc)[8/35]# encapsulation {llc|vc}
Using PVC channels in bridged Ethernet mode
The PVC offers a bridged Ethernet connection as specified in RFC1483, which can be used as an IP link e.g.
with DHCP to assign the address, DNS server, and default gateway. To do this, you bind an IP interface to the
PVC like it would be done to a normal Ethernet port.
Step 1 node(pvc)[vpi/vci]# [no] bind interface <if-
name>
Using PVC channels with PPPoE
The RFC1483 bridged Ethernet connection can also be used for PPPoE. To do this, you enter PPPoE mode
within the PVC mode. All PPPoE commands apply as if the PVC was a regular Ethernet port.
Step 1 node(pvc)[vpi/vci]# pppoe
Step 2 node(pppoe)# session <name>
Step 3 node(session)[<name>]# bind subscriber
<subscriber-name>
Step 4 node(session)[<name>]# no shutdown
Setting up permanent virtual circuits (PVC)
PPPoA is not supported.
Table 10. PVC Commands
Command
Table 11. PVC channels in bridged Ethernet mode
Command
Table 12. PVC channels in PPPoE mode
Command
4 • DSL Basic Configuration
Purpose
Creates PVC 8/35 and enters configuration
mode for this PVC. The "no"-variant deletes the
PVC configuration.
Sets the encapsulation to be used. Optionally
select either LLC encapsulation or VC multiplex-
ing for this PVC.
Default: llc
Purpose
Associates an IP interface configuration with this
PVC.
Purpose
Enters PPPoE configuration mode for this PVC.
Defines a PPPoE session.
Links the session to a subscriber definition.
Enables the PPPoE session
44