Introduction; Steps For Setting Up A New Smartnode - Patton SmartNode 4830 DSL Series User Manual

SmartNode 4830 DSL Series User Manual

Introduction

This chapter leads you through the basic steps to set up a new SmartNode and to download a configuration.
Patton SmartNodes can be used for a wide variety of IP-based network applications. To support and ease the
configuration of the SmartNodes configuration, templates for the most important applications are available on
the Patton server at www.patton.com/smartnode.
The main steps for setting up a new SmartNode are shown in
1
Configure IP address
2
Connect the SmartNode to the network
3
Load configuration
Note
You can manually configure the
SmartNode. You do not have to load a
configuration file.

Introduction

Console port
Ethernet interface
ETH0
Figure 10. Steps for setting up a new SmartNode
3 • Getting started with the SmartNode
figure 10.
PC or workstation
Serial
with VT-100
interface
emulation terminal
Network
interface
Network
3. Load configuration
Network
1. Download configuration example
PC or workstation
or VT-100 emulation
terminal
2. Modify configuration
Internet
Patton Web server
with configuration examples
33