Table of Contents
Advertisement
SmartNode 4830 DSL Series User Manual
Power source
If you suspect that your AC power is not reliable, for example if room lights flicker often or there is machinery
with large motors nearby, have a qualified professional test the power. Install a power conditioner if necessary.
Location and mounting requirements
The SmartNode VoIP IAD is intended to be placed on a desktop or similar sturdy, flat surface that offers easy
access to the cables. Allow sufficient space at the rear of the chassis for cable connections. Additionally, you
should consider the need to access the unit for future upgrades and maintenance.
Installing the VoIP IAD
SmartNode VoIP IAD installation consists of the following:
•
Placing the device at the desired installation location (see section
•
Installing the interface and power cables (see section
When you finish installing the SmartNode, go to chapter 3,
Mounting the VoIP IAD
Place the VoIP IAD on a desktop or similar sturdy, flat surface that offers easy access to the cables. The VoIP
IAD should be installed in a dry environment with sufficient space to allow air circulation for cooling.
Note
Connecting cables
WARNING
CAUTION
Installing VoIP IAD cables takes place in the following order:
1. Installing the RJ-11 voice port (FXS) cable or cables (see section
VoIP IAD's FXS and FXO interface ports"
2. Installing the 10/100 Ethernet port cable (see section
3. Installing the DSL cable (see section
4. Installing the power input (see section
Installing the VoIP IAD
For proper ventilation, leave at least 2 inches (5 cm) to the left,
right, front, and rear of the SmartNode VoIP IAD.
Do not work on the system or connect or disconnect cables during
periods of lightning activity.
The interconnecting cables shall be acceptable for external use and
shall be rated for the proper application with respect to voltage, cur-
rent, anticipated temperature, flammability, and mechanical service-
ability.
on page 27)
"Installing the DSL cable"
"Connecting to external power source"
"Mounting the VoIP IAD"
"Connecting cables"
on page 26)
"Getting started with the SmartNode"
"Installing an interface cable on the
"Installing the Ethernet cable"
on page 30)
2 • Hardware installation
on page 26)
on page 32.
on page 29)
on page 31)
26
Advertisement
Table of Contents
