User Administration - Sena PS110 User Manual

**B0ff000005b157
Firmware upgrade failed !
Now reboot ...

5.8. User administration

User can enable port authentication (see section 4.2.3.1 TCP mode), then user should enter correct
user ID and password of each port when he tries to access the serial port.
The user ID and password for each serial port can be set using this menu. When user adds a new
user for serial port, he can also assign permissible serial ports to the user selectively, as shown on
Figure 5-12 Port user administration.
NOTE: System user(root) cannot access serial ports unless he is also added as a port user in this
menu.
Figure 5-11 Firmware upgrade failure message
Figure 5-12 Port user administration
Figure 5-13 Port user configuration
71