Ps410/810 Panel Layout - Sena PS110 User Manual

2.1.2. PS410/810 Panel Layout

The PS410/810 has three groups of LED indicator lamps to display the status, as shown in Figure 2-2
and Figure 2-3 (i.e. System, Ethernet and Serial ports). The first two lamps on the left side indicate
Power, Ready(PS810 only). The next two lamps are for Ethernet Link and Act. Next lamps indicate
Receive and Transmit of the serial port.
Table 2-2 describes the function of each LED indicator lamp.
Lamps
System Power
Ready
Ethernet LINK
Act
Serial port Rx
Tx
There is a factory reset switch near by Serial console port and user can use this switch to restore
factory default configuration.
For PS410 there are 4 DIP switches to set communication type of serial port. (Please refer to Section
Figure 2-1 The panel layout of the PS110
Table 2-2 LED indicator lamps of the PS410/810
Function
Turned on if power is supplied
Turned on if system is ready to run (PS810 only)
Turned on if connected to Ethernet network
Blink whenever there is any activities such as incoming or outgoing packets
through the Pro Series Ethernet port
Blink whenever there is any incoming data stream through the serial port of
the Pro Series
Blink whenever there is any outgoing data stream through the serial port of
the Pro Series
13