Sena PS110 HelloDevice Pro Series Quick Start Manual

Quick Start Guide

PS110
HelloDevice Pro Series
C o m p l i a n t
Set DIP Switch & Pin-outs
Set serial DIP switch according to your
serial device requirements(RS-232/422/485)
Connection
Connect serial device
C ation
User can choose one of the following processes
Default Log-in ID/Password is root/root.
2. C ation using the Hyper terminal or Telnet
Connect to host PC. Then, slide Data/Console switch to the Console side.
9600 Baud rate/8 Data bits/None Parity/1 Stop bits/
No Hardware flow control
After login, "editconf" command will allow you to get into
the text-menu driven interface. Then menu screen is displayed.
DIP
Switch
Setting
DB-9
Pinouts
* Please note that the power of the Pro Series should be
tur
Connect Ethernet cable
HelloDevice Manager and User Manual are available for
download from Sena website at
http://www.senaindustrial.com/support/downloads/.
For more information, refer to the user manual.
Visit us at
Copyright 1998-2012, Sena Technologies, Inc. All rights reserved.
ON ON
RS-232 Mode RS-422/485 Full Mode
RS232 RS422
(console and serial ports) (serial ports only)
1 DCD Tx+
2 Rx RX+
3 Tx RTS+
4 DTR CTS+
5 GND GND
6 DSR TX-
7 RTS RTS-
8 CTS RX-
9 - CTS-
ore changing the serial communication type.
Connect Power supply
www.senaindustrial.com
ON
RS-485 Half Mode
RS485
(serial ports only)
Tx+
RX+
-
-
GND
TX-
-
RX-
-