Connecting The Hardware; Connecting To The Network - Sena PS110 User Manual

4.2.6 and Appendix A for more detail information of serial communication type and its connection)

2.2. Connecting the Hardware

This section describes how to connect the Pro Series to the equipment for initial testing.
- Connect the Pro Series to an Ethernet hub or switch
- Connect the device
- Connect a power source to the Pro Series

2.2.1. Connecting to the network

Plug one end of the Ethernet cable to the Pro Series Ethernet port. The other end of the Ethernet
cable should be connected to a network port. If the cable is properly connected, the Pro Series will
have a valid connection to the Ethernet network. This will be indicated by:
The [Link] lamp will light up green.
The [Act] lamp will blink to indicate incoming/outgoing Ethernet packets
Figure 2-2 The panel layout of the PS410
Figure 2-3 The panel layout of the PS810
14