Removing A Secondary Keypad (Controller); Output List; Z-Wave Troubleshooting - Honeywell Tuxedo User Manual

Removing a Secondary Keypad (Controller)

To remove the Secondary controller, do the following:
ICON
1. At the Primary Controller keypad:
a) Press Delete.
2. At the Secondary Controller keypad:
a) Press Delete.

Output List

To access the Output List, from the "Home" screen, do the following:
ICON
1. Press the Automation and Output icons.
2. Enter your Authorized Code.
3. Use the OFF or ON button to control outputs.

Z-Wave Troubleshooting

PROBLEM
Cannot add new Make sure the Z-Wave device is within range of the Tuxedo Touch keypad. You may need to move
device. the device closer to the keypad. Refer to the Z-Wave device Instruction Guide for proper range.
Device is within
proper range but
still is not included.
Highlighted device
will not delete.
Automation (cont'd)
ACTION
ACTION
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the "Home" screen and then press the
Z-Wave Setup icon to display the "Z-Wave Device Management" screen.
b) If the device does not appear on the screen, press the Z-Wave Exclude/Delete icon.
2. At the Z-Wave device, press the Function Key. The screen will display a message
"Device Removed".
3. At the Tuxedo Touch Keypad:
a) Include device again.
When deleting a device, if the selected device remains on the screen, highlight the device
name and press the Removed Failed Device icon.
NOTES
Both keypads will display, "Device Removed" and the Secondary
Controller keypad will revert back to the Primary Controller.
NOTES
SOLUTION
41