Honeywell Tuxedo User Manual page 34

Include a Door Lock
Assemble the Z-Wave door lock. NOTE: Be sure the door lock orientation/handedness is correct. Refer to the Door Lock's
Instruction Guide and connect necessary cables, then install batteries. Enroll the door lock adjacent to the keypad refer to the
Door Lock's Instruction Guide for enrollment procedure.
NOTE: Program the user code in the control panel prior to programming that user code into the door lock. User Codes must be 4-
digits.
Include a door lock device as follows:
ICON
1. At the Tuxedo Touch keypad:
a) Press the Automation icon From the "Home"
screen and then press the Z-Wave Setup
icon to display the "Z-Wave Device
Management" screen.
b) Press the Z-Wave Include/Add icon.
2. At the Door Lock:
a) Press the *Function Key on the door lock.
b) Program the selected user code from the
panel; refer to Door Lock User Guide.
Include a Honeywell Thermostat
Install Honeywell Thermostat according to the manufactures instructions. Device should be mounted in the final location and
tested before adding it to the system.
Note: Honeywell is not responsible for property damages due to improper setting of the thermostat modes.
To include a Honeywell Thermostat into a Z-Wave network, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the "Home"
screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management" screen.
b) Press the Z-Wave Include/Add icon.
Automation (cont'd)
ACTION
ACTION
NOTES
Note: Door lock devices may vary; follow the instructions in the Users
Guide for your specific door lock to include properly and to program a new
user code.
The keypad displays a series of messages:
"Please press *function key on device"
"Adding to Security Network"
"Device added successfully"
* Enrollment procedure may vary depending on the door lock device. Refer
to the door lock instructions for enrollment procedure.
Note: If software is upgraded on the Tuxedo Touch keypad, re-include the
door lock and re-set the user code in the door lock.
NOTES
Note: If installing another brand of thermostat, follow the instructions in the
Users Guide for that specific thermostat to include properly into the Z-Wave
network.
The keypad displays a series of messages:
"Please press *function key on device"
* If not using a Honeywell thermostat, enrollment procedure may vary. Refer
to the thermostat instructions for enrollment procedure.
34