How to Display Faults
The Display Faults function is used when you see a "Not Ready Fault" message and want to determine where the fault is and
what type of fault it is. To display faults do the following:
ICON
1.
From the "Security" screen, press the
DISPLAY FAULTS icon.
2. If the fault cannot be corrected, you may
choose to bypass a zone by pressing the zone
and highlighting it and then pressing the
BYPASS SELECTED icon.
Show Zones Icons
Clear
Bypass
Refresh
Bypasses
Selected
Data
How to Bypass Zones
The Bypass function is used when you want to arm your system with one or more zones left open. Bypassed zones are
unprotected and do not cause an alarm when violated while your system is armed.
• Residential systems do not allow you to bypass fire, carbon monoxide or emergency zones. On commercial fire systems, a
specified user may be allowed to bypass fire, carbon monoxide and system zones if the user was enabled by your system
installer.
• Limits apply as to how many zones can be bypassed at one time. These limits are ten zones on residential systems and
five zones on commercial systems.
Security (cont'd)
ACTION
Distressed
Bypass All
Zones
NOTES
A listing of faulted and/or bypassed zones is displayed.
As applicable, take corrective action such as closing a window or door to
correct the fault.
Distressed Zones Icons
Troubles
Faults
Alarm
13
Bypass
Low
All
Zones
Battery