How To Display Faults; How To Bypass Zones - Honeywell Tuxedo Touch Series User Manual

SCAN SECURITY

How to Display Faults

The Display Faults function is used when you see a "Not Ready Fault" message and want to determine where the fault is and
what type of fault it is. To display faults do the following:
ICON
1.
From the "Security" screen, press the
DISPLAY FAULTS icon.
2. If the fault cannot be corrected, you may
choose to bypass a zone by pressing the zone
and highlighting it and then pressing the
BYPASS SELECTED icon.
Show Zones Icons
Bypass
Clear
Refresh
Selected
Bypasses
Data

How to Bypass Zones

The Bypass function is used when you want to arm your system with one or more zones left open. Bypassed zones are
unprotected and do not cause an alarm when violated while your system is armed.
• Residential systems do not allow you to bypass fire, carbon monoxide or emergency zones. On commercial fire systems, a
specified user may be allowed to bypass fire, carbon monoxide and system zones if the user was enabled by your system
installer.
• Limits apply as to how many zones can be bypassed at one time. These limits are ten zones on residential systems and five
zones on commercial systems.
Security (cont'd)
ACTION
A listing of faulted and/or bypassed zones is displayed.
As applicable, take corrective action such as closing a window or door to
correct the fault.
Distressed Zones Icons
Bypass All
Distressed
Zones
NOTES
Faults
Troubles
Alarm
13
Low
Bypass
Battery
All
Zones