Sectional Drawing Parts List; General Arrangement Drawing; Certification; Other Relevant Documentation And Manuals - Flowserve FM Centrifugal Pump PCN=71576526 User Instructions

8.2 Sectional drawing parts list

ITEM
1130 Suction casing
1140 Discharge casing
1150 Stage casing
1410 Diffuser
1470 Diffuser plate
2250 Radial impeller
2410 Interstage sleeve
2450 Shaft sleeve
2540 Thrower
2905 Washer
2910 Shaft nut
4120 Gland
4130 Gland packing
4132 Stuffing box bushing
4590 Gasket
4610 O-ring
6515 Drain plug
6571 Tie bolt
6572 Stud
6577 Hexagon head bolt
6578 Threaded plug
6581-01 Hexagon nut
6581-02 Hexagon nut
6700 Key
6812 Grooved pin
8020 Motor for close coupling
9331 Cover plate
Page 29 of 32
FM USER INSTRUCTIONS ENGLISH 71576526 - 03/07
NOMENCLATURE

8.3 General arrangement drawing

The typical general arrangement drawing and any
specific drawings required by the contract will be
sent to the Purchaser separately unless the contract
specifically calls for these to be included into the
User Instructions. If required, copies of other
drawings sent separately to the Purchaser should be
obtained from the Purchaser and retained with these
User Instructions.

9 CERTIFICATION

Certificates determined from the Contract
requirements are provided with these instructions
where applicable. Examples are certificates for CE
marking, ATEX marking etc. If required, copies of
other certificates sent separately to the Purchaser
should be obtained from the Purchaser for retention
with these User Instructions.
10 OTHER RELEVANT
DOCUMENTATION AND MANUALS
10.1 Supplementary User Instructions
manuals
Supplementary instructions such as for a driver,
instrumentation, controller, seals, sealant system etc
are provided as separate documents in their original
format. If further copies of these are required they
should be obtained from the supplier for retention
with these User Instructions.

10.2 Change notes

If any changes, agreed with Flowserve, are made to
the product after its supply, a record of the details
should be maintained with these User Instructions.

10.3 Additional sources of information

Reference 1:
NPSH for Rotor dynamic Pumps: a reference guide,
Euro pump Guide No. 1, Euro pump & World Pumps,
Elsevier Science, United Kingdom, 1999.
Reference 2:
th
Pumping Manual, 9 edition, T.C. Dickenson,
Elsevier Advanced Technology, United Kingdom, 1995.
Reference 3:
nd
Pump Handbook, 2 edition, Igor J. Karassik et al,
McGraw-Hill Inc., New York, 1993.
Reference 4:
ANSI/HI 1.1-1.5, Centrifugal Pumps - Nomenclature,
Definitions, Application and Operation.
Reference 5:
ANSI B31.3 - Process Piping.
flowserve.com